EL6N137 6N137 DIP-8 New logic output of high speed Optocoupler

• 6N137 comes up with 10Mbit/sec speed, which makes it one of the high speeds optocoupler.
• It has the capability of 5Volt CMOS.
• Low voltage AC and DC can be applied directly to the output and input. Its performance will be measured according to temperate on both currents.
• IC comes with 5mA current operating capacity.
• The output of optocoupler always comes in logic state, HIGH and LOW.
• 6N137 is a choice of CMR because of its high common-mode transient immunity.
• Due to availability of IC in multiple packages as DIP and SMD, it can be used with any circuit.
• Its output is based not only input, but it also has an effect by a third pin which comes in handy during using the IC with camera flash.
• The receiver end has an NMOS transistor which saves it from the leakage.

SPECIFICATIONS

• The maximum power supply input for IC is 7V but typical power input is 5V.
• The minimum input voltage for the HIGH state is 2V and for maximum input for the LOW state is 0.8V.
• IC gives the propagation delay of 50ns approximately.
• The operating temperature for IC is -40 to 100 and its storage temperature range is -55 to 150.
• The Solder temperature range for reflow soldering and lead soldering is 260, above this optocoupler performance will be affected.
• Power dissipation for IC is 85mW.
• The external output pull-up resistor range is 330 to 4k.