The MPLAB PICkit3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit3 is connected to the design engineer’s PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming.
FEATURES
-
Full-speed USB support using Windows standard drivers
-
Real-time execution
-
Processors run at maximum speeds
-
MPLAB IDE compatible (free copy included)
-
Built-in over-voltage/short circuit monitor
-
Firmware upgradeable from PC/web download
-
Totally enclosed
-
Supports low voltage to 5 volts (1.8v to 5.0v range)
-
Diagnostic LEDs (power, active, status)
-
Read/write program and data memory of microcontroller
-
Erase of all memory types (EEPROM, ID, configuration and program) with verification
-
Freeze-peripherals at breakpoint
-
Program up to 512K byte flash with the Programmer-to-Go
